Siemens F01360

Hatanın Anlamı

Fault: Topology: Actual topology not permissible

Olası nedenler

• The detected actual topology is not permissible
• Fault value (r0949, interpret hexadecimal): ccccbbaa hex: cccc = preliminary component number, bb = no significance, aa = fault cause aa = 01 hex = 1 dec: Too many components were detected at the Control Unit
• A maximum of 199 components is permissible
• aa = 02 hex = 2 dec: The component type of a component is not known

Çözüm ve Güvenli İlk Kontroller

1. For fault cause = 1: Change the configuration
2. Connect less than 199 components to the Control Unit
3. For fault cause = 2: Remove the component with unknown component type
4. For fault cause = 3, 4, 5: Establish a valid combination

Güvenlik: Enerjiyi kesmeden pano içi işlem yapmayın; emin değilseniz yetkili teknisyene danışın.

İlgili Siemens hata kodları