Siemens F01357

Бренд: SiemensМодель: SINAMICS G120 CU250S2Код ошибки: F01357

Что означает ошибка

Fault: Topology: Two Control Units identified on the DRIVE-CLiQ line

In the actual topology, 2 Control Units are connected with one another through DRIVE-CLiQ
As standard, this is not permitted
It is only permitted, if the OA application OALINK is already installed on both Control Units
Fault value (r0949, interpret hexadecimal): yyxx hex: yy = connection number of the Control Unit at which the second Control Unit is connected xx = component number of the Control Unit at which the second Control Unit is connected Note: Pulse enable is withdrawn and prevented

remove the DRIVE-CLiQ connection, restart the systems, install OALINK on both Control Units and commission.
remove the connection to the second Control Unit and restart.
for the S120M component DRIVE-CLiQ extension, interchange the hybrid cable (IN/OUT).

Безопасность: не работайте внутри шкафа без снятия напряжения; при сомнениях обратитесь к квалифицированному специалисту.