Zeror.ai Error Codes Siemens F01800

Siemens F01800

Brand: SiemensModel: SINAMICS G120 CU250S2Error code: F01800

What the Fault Means

Fault: DRIVE-CLiQ: Hardware/configuration error

Likely causes

  • A DRIVE-CLiQ connection fault has occurred
  • Fault value (r0949, interpret decimal): 100 ..
  • 107: Communication via DRIVE-CLiQ socket X100 ..
  • X107 has not been switched to cyclic operation

Solution and Safe First Checks

  1. ensure that the DRIVE-CLiQ components have the same firmware versions.
  2. avoid longer topologies for short current controller clock cycles.
  3. check the DRIVE-CLiQ cables at the Control Unit.
  4. remove any short-circuit for motors with DRIVE-CLiQ.
  5. carry out a POWER ON.
  6. check the electrical cabinet design and cable routing for EMC compliance

Safety: do not work inside the panel without isolating the power; if unsure, consult a qualified technician.

Related Siemens error codes

Source: the Zeror.ai industrial fault database and Siemens technical documentation. This page is for information; on critical systems follow the manufacturer's manual and authorised service.

Siemens F01800 · Zeror.ai